Machine Reference Title: Procedures for sewing a DST file using PC Date: February 4, 2009 Models: BE-0901-PC, BE-1201-PC, BE-12
3. The bottom colors, of the Needle Bar Change window, (1-12) represent the 12 needles on the machine. 4. In this example the design has 8 color
6. Now just drag each color change bubble over the needle on the machine that you want that color to be. 7. As you move each bubble over a needle
Setting sewing speed 1. All DST files loaded in to the software will default to the fastest “Speed Range”. Left click on the “Down” button to adjust
Sending design to the machine 1. Left click on the “Start” icon to send the design to machine. You are now finished on the computer.
Operations on the machine panel 1. The “Ready” light should be on if the design was sent to the machine. 2. If “HOOP” is displayed on the machine
2. It may ask you if you want to save the design previously loaded. (This will save the design in an ECS format) Save – Save design without being abl
Loading a DST file 1. Left click on the Explorer icon. 1. Left click on the drive or folder containing the DST file you want to read in. In this
2. On the right hand side of the window, double left click on the design that you want to load. 3. A “Create Icon” window will be displayed. Left
4.4.4.4. A window appears asking “How many times is feed required to be A window appears asking “How many times is feed required to be A window
Loading embroidery hoop to use (Note: If using some aftermarket hoops, such as a FastFrame, this step is optional.) 1.1.1.1. Left click onLeft
3. There are two folders containing hoop outlines, Hoop and Hoop2. Please use the correct folder for your model. See below: (Note: These two folders
5.5.5.5. Try to use the smallest size hoop possible for good embroidery. Try to use the smallest size hoop possible for good embroidery. Try to us
Setting color sequence 1. Left click on the “Needle Bar Change” icon. 2. The “Needle Bar Change” window appears. Needle Bar Change icon
Comentarios a estos manuales