Brother DCP-340CW Guía de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 178
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
4
4 - 1
4
Control panel setup
LAN menu
Before using your Brother product in a network environment, you need to configure the correct TCP/IP
settings. For more information, see Configuring your machine for a network with an Ethernet cable connection
on page 2-1 or Configuring your machine for a wireless network on page 3-1.
In this chapter, you will learn how to configure the network settings using the control panel, located on the
front of the machine.
The LAN menu selections of the control panel allow you to set up the Brother machine for your network
configuration. Press Menu/Set, then press the appropriate number, 5 for LAN for example. Proceed to the
menu selection you wish to configure. See Function table and default factory settings on page B-4.
Please note that the machine is supplied with the BRAdmin Professional Windows
®
software and Remote
Setup applications for Windows
®
and Macintosh
®
, which also can be used to configure many aspects of the
network. See Changing the print server settings on page 2-5 for wired connection or Changing the print server
settings on page 3-13 for wireless connection.
1.TCP/IP (Wired) / 2.TCP/IP (WLAN)
If you connect the machine with the Ethernet cable to your network, use the TCP/IP (Wired) menu selections.
If you connect the machine to the wireless Ethernet network, use the TCP/IP (WLAN) menu selections.
This menu has nine sections: Boot Method, IP Address, Subnet Mask, Gateway, Node Name, WINS
Config, WINS Server, DNS Server and APIPA.
1.BOOT Method
This selection controls how the machine obtains the IP address for itself. The default setting is Auto.
(For DCP-340CW)
1
Press Menu.
2
Press or to select 3.LAN.
Press Set.
3
(For Wired) Press or to select 1.TCP/IP(Wired).
(For Wireless) Press or to select 2.TCP/IP(WLAN).
Press Set.
4
Press or to select 1.BOOT Method.
Press Set.
5
Press or to select Auto, Static, RARP, BOOTP or DHCP.
Press Set.
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 177 178

Comentarios a estos manuales

Sin comentarios